Issue link: https://www.ascpskindeepdigital.com/i/1503366
90 ASCP Skin Deep Summer 2023 Step-by-Step Lash Lamination ELLEEBANA 1 3 2 6 7 Step 1 Gently but thoroughly cleanse the entire eye area with Elleebana Makeup Remover on a cotton round or makeup pad. If needed, double cleanse to ensure no residue remains. Lightly rinse with warm water to remove any remaining makeup remover and then dry with a tissue. Step 3 Use a Flex Shield or Flex Rod to avoid applying adhesive on the back of the rod. Place the rod or shield on the very edge of the lid, as close as possible to the root of the lashes. Continue this process the entire length of the lash line. Ensure the outer corners are not drooping and that no lashes are caught underneath the rod. Step 2 Protect the lower lashes by taping them down with under-eye pads, micropore tape, or sensitive tape. In addition to protection, this ensures the lower lashes are not attached to the upper lashes and lifted in the same upward direction. Step 6 Open Step 1 of the Elleeplex Profusion Lash Lamination System and dispense into a tray, bowl, glue ring, or mixing dish. Use an application brush to paint the Step 1 lotion (lamination/lift lotion) from the base of the lashes to ¾ of the way up the lash. For a more dramatic lift, extend the lotion further to coat most of the lash. Step 7 After the lamination lotion has processed, wipe off the lamination lotion with a dry cotton bud or micro brush, being careful not to disrupt the location of the lashes along the silicone rod. Relift any disturbed lashes. Remember to use micro brushes at this stage and avoid cross contamination of touching the brush from your adhesive to the client's lashes. Step 8 Combine Step 2 setting lotion with Elleeplex ReGEN 2.0 Cream in a ratio of eight parts setting lotion to one part ReGEN in a mixing dish. Apply the setting lotion to the lashes with a clean application brush from the base of the lash up the entire lash, allowing the ReGEN Next Gen to nourish and hydrate the lash.